All I needed to do was solder the module to the board and then the headers. All the was left to do was to short GPIO 00 to ground when powering it up to put it "flash" mode.
Wednesday, May 10, 2017
ESP-12F Adapter Plates
I finally broke down and bought some "standard" ESP-12 adapter plates that I see everywhere,..
The nice thing about then that I noticed is that it already includes the pull-up and pull-down resistors needed just to get the ESP-12 working.
All I needed to do was solder the module to the board and then the headers. All the was left to do was to short GPIO 00 to ground when powering it up to put it "flash" mode.
All I needed to do was solder the module to the board and then the headers. All the was left to do was to short GPIO 00 to ground when powering it up to put it "flash" mode.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment